Non-contact voltage tester detects 12 - 1000 VAC
AC/DC voltage tester tests 12 - 600 VAC/VDC at nine useful levels
GFCI outlet tester with LED lights, indicates wiring problems


This 3-Piece Tool Set includes Cat. No. NCVT2P Dual Range Non-Contact Voltage Tester, 12 - 1000-Volt AC, Cat. No. ET60 AC/DC Voltage Tester, and Cat. No. RT210 GFCI Receptacle Tester. The NCVT2P is a non-contact voltage tester that detects 12 to 1000V AC and indicates the presence of voltage in cables, cords, circuit breakers, light fixtures, switches, outlets and wires as well as AC voltage in doorbells, thermostats, low voltage lighting and irrigation systems. The ET60 is a solid-state, low impedance, electronic voltage tester. It measures AC/DC voltages up to 600V. The ET60 does NOT require batteries; it is powered by the applied voltage. The GFCI Outlet tester is designed to detect the most common wiring problems in standard and GFCI receptacles. A convenient chart on the tester helps determine wiring condition in outlet, based on LED lights results. Conditions indicated: open ground, reverse polarity, open hot, open neutral, hot/ground reversed.


Tool set includes non-contact voltage tester, AC/DC voltage tester and outlet tester
Dual range non-contact voltage tester indicates low voltage (12-Volt to 48-Volt AC) and standard voltage (70-Volt to 1000-Volt AC) allowing broad application
Detects 12-Volt to 1000-Volt AC with simultaneous visual and audible voltage indicators
Non-contact detection of low voltage in security, entertainment, communications, environmental control and irrigation systems
Lightweight, compact tool with pocket clip provides convenient storage and quick access
CAT IV 1000 V rating provides expanded operation and protection
Screw-thread battery cap with O-ring ensures protection against dust and water ingress
IP67: dustproof and waterproof
ET60 tests AC/DC voltage from 12-Volt-600-Volt at 9 useful levels aligned with commonly used voltages
Uses standard replaceable multimeter test leads for versatility
CAT IV 600-Volt modern solid-state design for safety
Easy to use bright LED display clearly reports the voltage present in the circuit being tested
Integrated test-lead holders are used for lead storage or for holding the probes correctly spaced for insertion into tamper-resistant US-style outlets
Inherent low input impedance reduces the possibility of falsely reading ghost or stray voltages on non-energized circuits
Batteries not required, as tester is powered by the applied voltage in the circuit being tested
Outlet tester detects the most common wiring problems in standard and GFCI receptacles
Works on GFI outlets and confirms operation of the ground fault protective device
Conditions indicated: open ground, reverse polarity, open hot, open neutral, hot/ground reversed